Build A Maximum Size Snowy Island In Minecraft With Two Giant Horn Shaped Peaks Joined By
This Minecraft structure was generated by BlockGPT from the prompt below.
Build a maximum size snowy island in Minecraft with two giant horn shaped peaks joined by a knife edge ridge in the back, similar to the reference picture of a white island with a gray rocky mountain, but WITHOUT the flat prairie in front. Footprint about 1024 x 1024 blocks including surrounding dark deep water at Y=63, island about 900 x 800, mountain summit at the build limit Y=320. Mood: cold, silent, untouched wilderness at night with soft snowfall. ISLAND SHAPE: Irregular organic outline with bays and rounded capes, a snowy tongue peninsula on the east shore, a dark sea cave on the south side. The whole coast is edged with a 2 to 4 block band of packed ice and blue ice at the waterline, with 3 to 6 block ice cliffs and white snow above. Everything is covered by snow layers 1 to 8 over stone, andesite and dirt. Do not make any flat plain or prairie. The front of the island is rolling snowy foothills, drifts, small terraces, frozen coves, shallow frozen ponds and rocky outcrops, always uneven and never flat. Scatter large snow covered boulders and a few ice spikes near the shoreline. THE MOUNTAIN: Place it in the back, about 60 percent of the island width and covering the entire north and east side. Two enormous sharp horns like the Matterhorn: the tallest at Y=320 on the east and a slightly shorter one at Y=295 on the west, joined by a thin knife edge ridge at Y=250 with a deep notch in the middle. Each horn has four steep faces of dark gray stone and deepslate with strong horizontal rock bands, a pointed snow tip on the top 40 blocks, and hanging blue ice on the north faces. Around them place three small satellite peaks of 140 to 190 blocks, a rocky skirt of foothills and a wide snowy col between the horns at the base. Make it HUGE, steep and dramatic, with sheer faces of 100 blocks and a dominating silhouette seen from far across the water. DETAILS ON THE MOUNTAIN: Make the faces nearly vertical for the top 120 blocks with thin ledges of snow, long vertical streaks of ice, snow plumes blowing off the summits, and a small frozen lake in the col between the horns. Add rock fans and scree under every face and two small ice caves under the north walls. Add soft rounded snow drifts against every rock and ledge. Leave small frozen puddles of blue ice between boulders. Vary snow depth so no two slopes look the same. Let long smooth snow ripples run along the leeward slopes. Hide a few small ice caves along the shoreline. Keep silhouettes bold and readable from far away. Add faint blue shadows in every hollow. Round every shoreline corner. Add scattered snow capped boulders. SNOW AND ICE: Make the snow look soft and deep, using layers 1 to 8 for rounded drifts, powder snow pockets in hollows, packed ice patches on slopes and blue ice on frozen ponds and cliff edges. Keep the rock above the snow line bare and weathered with snow only on ledges, and the lower island fully white. Let the transition from snow to rock be ragged and natural, never a clean line. SURROUNDING SEA: Dark deep water with thin floating ice sheets, a few icebergs of white and blue ice around the island, a shallow ice shelf along the coast, and small broken ice floes drifting near the cape. The water around the island fades from pale teal at the shore to deep dark blue offshore. NATURE: Keep the land empty and untouched. No buildings, no paths, no trails, no fences, no lanterns and no trees. Only snow, ice, rock and water, so it can be used later as a clean base. Leave one wide gently sloped south face on the mountain with no cliffs or crevasses. STYLE RULES: Natural, irregular, hand sculpted voxel terrain with rounded snow shapes on the island and sharp jagged rock on the mountain. Palette: white, light gray, dark gray, ice blue. Avoid straight lines, grid patterns and flat floors. Output a clean, buildable schematic with all blocks supported and no floating pieces.
- Download
- .schem for WorldEdit or FastAsyncWorldEdit
- Made with
- BlockGPT, from a text prompt
To use it, drop it in your schematics folder and run //paste. The file works in Minecraft Java Edition.
